Suggested Maintenance Checklists
Every Trip
- Electrical System – Check and service batteries.
- Entry Door(s) – Make sure door latches and locks function properly.
- Emergency Egress Window(s) – Open and close the Emergency Egress Window(s) each trip.
- Hitch Coupler – Check for damage & wear.
- Plumbing System – Drain Fresh Water Holding Tanks after every trip. Sanitize Annually (or as needed). Drain & Flush Black & Gray Water Holding Tanks.
- Safety Equipment – Check operation of detectors – recharge and replace batteries every 6 months if equipped. Test and check fire extinguisher for proper charge. Test and confirm egress (exit) window(s) function properly.
- Slide Rooms – Check slide roof for debris – clear as necessary. Check and clean all seals.
- Wheels & Tires – Check wheel lugs for proper torque. Inspect tires for wear / damage / etc. Check tire inflation pressure (see tire label for pressures).
Monthly
- Baggage Doors – Confirm that doors seal tight and are not leaking. Spray lock tumblers with dry graphite.
- Electrical System – Check and service batteries. Test all GFI outlets.
- Entry Door(s) – Lube hinges with Silicone or Teflon-based dry lube. Adjust the screen door and latch.
- Entry Steps – Clean & apply Silicone or Teflon-based dry lube.
- Exterior Moldings – Inspect sealant for voids/gaps/cracks and re-seal as necessary.
- Frame / Underbelly – Clean as necessary. Check frame for chipped paint and rust, repaint as necessary.
- Hitch Coupler – Clean and lubricate (with grease).
- Plumbing System – Check hoses, fittings, and pipes for leaks. Tighten as required.
- Roof And Roof Attachments – Inspect sealant for voids/gaps/cracks and re-seal as necessary.
Every 3 Months
- Exterior Fiberglass / Metal – Wash with warm water & mild detergent. Apply non-abrasive wax (except on decals).
- Roof – Clean roof with water and mild detergent. Clean and lube roof vent mechanisms with light oil.
Annual
- Appliances – Check settings & adjustments per manufacturers guide; Make sure burner tubes / vents are clean/unobstructed; Clean & sanitize.
- Awnings – Wash with warm water and mild detergent. Clean moving parts & apply Silicone or Teflon-based dry lube.
- Axles / Suspension – Check U-bolts, springs & hangers for damage. Check torque – all bolts (see mfg. guide for specs).
- Brakes /Wheel Hubs – Have brakes and hubs inspected by a certified RV service technician. Check amp draw/shoe wear/adjustment (see mfg. guide for specs.). Lube bearings every 12 months / 12,000 miles (as required).
- Frame / Underbelly – Check for damage, loose wires, and debris.
- Hensley – Grease hitch ball
- LP System – Have the system tested for leaks by a qualified dealer. Have pressure and regulator setting checked by a qualified dealer.
- Plumbing System – Lubricate termination gate valve cables with Silicone or Teflon-based dry lube. Winterize system before storage (in cold weather locations).
- Slide Rooms – Slideout room adjustment performed by a certified RV service technician.